Terminating IPCAST(Unicast/Multcast) HW | Call Recording Reference

Terminating(active) recording: this term refers to situation when recorded media streams are sent by recorded device directly to the recorder

VSLogger Terminating IPCAST recording hw object and channel objects are configured in CLI Tool config hw ipcast mode.

Note: This mode doesn't require any special driver pre-installed and is always available in VSLogger server starting with version 4.8.1.0

CLI (Command Line Interface) (How to use CLI Tool - refer to CLI Tool Overview)		GUI (Graphical User Interface)
hw ipcast ? - use this command to display all available IPCAST configuration options `cli>(config)` `->hw ipcast` `cli>(config-hw_ipcast)` `->?` `help\|? - embedded help` `show - show current configuration` `exit - exit current configuration mode` `enable [y\|n] - enable/disable hw` `numdev [num] - num of ipcast devices``cli>(config-hw_ipcast)Use hw ipcast show - command to display current configuration` `cli>(config-hw_ipcast)` `->show` `----------------------------------------` `hw [ipcast]` `----------------------------------------` `available: y` `enabled: y` `numdev: 5cli>(config-hw_ipcast)`		IPCAST configuration menu can be reached by navigating through Setup->Hardware->Edit IPCAST Hardware settings to enable/disable, as well as configure number of devices.
Initial configuration steps 1. Enable ipcast hardware `cli>(config-hw_ipcast)` `->enable y` `cli>(config-hw_ipcast)`
2. Set max number of recorded endpoints Attention!!. This operation will add a specific number of channels of IPCAST type to the recorder channels list. Channels list will be updated on config reload command `cli>(config-hw_ipcast)` `->numdev 8` `cli>(config-hw_ipcast)`

CLI (Command Line Interface)(How to use CLI Tool - refer to CLI Tool Overview)